General

Ground wire connector for feed thru and tap joints. Fast production of long term stable terminations thanks to patented modified insulation piercing technique, wedge insulation piercing. For insulated ground wire o.d. 11.0-13.0 mm, wire size AWG 1.2,3 or 4 wires may be jointed.

Function

When the cover (CO) and the center part (CP) are screwed together, the spring washers (SW) are compressed.

This bolted joint will pull the wedge (W2) of the center part towards the wedge (Wl) of the cover. The wedges will squeeze one side of the cable (CA) resulting in it being pushed away in horizontal direction.

This in turn will make strands (ST) push on the insulation piercing knife (IPK).

This is the contact force (

). It is kept up by the spring washers.

NED 90113 Ground wire connector “QuickGrip”

Installation instruction

1. Unscrew and remove one cover.

2. Place the cables in the cover.

3. Remove number of insulation necessary cable tabs.

4. Place the cover on the centerpart.

5. Screw the parts together. Stop when the top the guide pin reach the reference level.

NOTE: Do not screw the parts tigheter together. Doing so may risk the long term stability by blocking the action of

the spring washers.

NED 90113 Ground wire connector “QuickGrip”

Installation instruction, for 6 mm² cable

2. Unscrew and remove one cover.

1. Place the fixture in the cover.

2. Place the fixture in the cover.

3. Remove necessary number of cable end and insulation tabs. The cable end shall be placed towards the insulation tab, if it is not feed through. Important that all 4 spikes on the knife will go through the cable

4. Place the cover on the centerpart.

NOTE: Do not place 50 mm² (AWG 1) and 6 mm² in the same cover. Only 1 cable in each slot.

6. Screw the parts together. Stop when the top the guide pin reach the reference level.

NOTE: Do not screw the parts tigheter together. Doing so may risk the long term stability by blocking the action of the spring washers.